搜索资源列表
UWB_Fifth_Order_Derivative
- Models UWB TX and RX using BPSK fifth derivative. MATLAB Release: R13 Descr iption: This m file models a UWB system using BPSK with the fifth order derivative of the gaussian pulse with correlation receiver and intgrator. -Models UWB TX an
UWB_BPSK_transreceiver
- MATLAB仿真uwb使用bpsk调制解调的发送(TX)和接收(RX)-MATLAB uwb bpsk use of modulation and demodulation of this (TX) and receive (RX)
MYMIMO
- 文件来源: 我的毕设 仿真结果: 在窄带Rayleigh快衰落信道下几种检测方法的误码率性能比较 说 明: 参数tx,rx,L,EbN0可以根据需要更改。 tx,rx是收发天线数,根据需要取值就好了,一般研究2发2收和4发4收 EbN0是信噪比取值范围,根据需要选择吧。取得点多当然算得慢。 L影响结果的波动性和误码率所能达到的下限,L值取得越大图像越接近真实情况。如果 EbN0最大值有20dB那么误码率可以达到10负4次方建议L不低于10000。 使用
matlab 高光谱工具箱
- matlab 高光谱工具箱,有RX探测,数据降为,全约束的最小二乘分解等算法
arma.rar
- ARMA模型建立程序,给出自相关序列,指定ARMA模型的P阶,Q阶参数,得出相应的参数值 function [bq ,ap]=armahat(rx,p,q),ARMA model for the establishment of procedures, to come from related sequences, designated the P-order ARMA model, Q-order parameters, the corresponding parameter value
RX
- 此算法使用于单波段或者多波段图像中的非监督异常检测,性能很好~-The algorithm used in single-band or multi-band image unsupervised anomaly detection, performance very good ~
work
- 距离分辨率 thrt0=1*pi/6 斜视角 angb=0.6*lamda/res_a 合成波束宽度 Rr=5000 目标中心到航迹垂直距离 V=100 飞机的航速 Tp=1e-6 脉冲宽度 T=10e-3 脉冲周期 B=0.5*c/res_r 脉冲频宽 Kr=B/Tp 频率调制率 fc=c/lamda 载波频率 Rx=Rr*tan(thrt0) 目标区中心横坐标 R0=Rr*sec(thrt0) 目标区中x心距离 Lc0=1.0*angb*R0
Simple_TOA
- This a simple position location algorithm using Least Square Estimation algorithm. Timing information is time of flight (TOA) of signal between Tx and Rx. This code generally describes the Positioning method, Also it plots final coordinate of node in
SingleCellofdm
- OFDM链路级的仿真器场景是单小区单用户,信号从发送端发送,在接收端进行信号估计。估计误差可以从接收和发送信号的不同得到。仿真器的输出是BLER/BER vs SNR。-OFDM Link-level simulator focus on a single-cell single-user scenario, where signal is transmitted from tx, and estimated at rx. Comparing the difference in tx/rx si
QPSK_chain
- Simulation of a baseband QPSK mod/demod: TX : a pseudo random bit stream generation, Serial to parallel conversion, QPSK Mapping (Gray coding), Signal power computation Channel : AWGN channel RX: Soft Demapping / Hard Demapping, Plot constellat
ofdm_webexample
- An example of OFDM modulation implemented in MATLAB with simulations for tx, rx.
bpskrxtx
- BPSK RX and TX used in cdma technology.
skyplot
- SKYPLOT for a given receiver position Y=skyplot(X,PRN,C,O) draws the skyplot for the receiver position. The required inputdata for the calculation of the skyplot X is N-by-3*M matrix, where N are the timesteps and M is the number of the Sat
DSB_AM_MATLAB
- 用来进行双边带幅度调制DSB_AM的MATLAB源程序。-Demonstration scr ipt for DSB-AM. The message signal is+1 for 0 < t < t0/3,-2 for t0/3 < t < 2t0/3, and zero otherwise.actually means Rx(m-1).
OFDM
- 该模型实现了一个通用的OFDM TX和RX,这是不依赖于任何特定的行业标准。该模型的目标是开发和研究不断(不是“突发”)载波同步和定时跟踪方案。该技术纳入然后可以扩展和修改,以标准的具体通讯套件。该模型采用了“收购”技术,它利用了循环前缀相关属性,以赶在试图完成罚款跟踪算法一帧的边界粗略的估计。该模型实现了一个16点64循环前缀的OFDM载波波形。在OFDM符号有16个飞行员,3后卫音(0,带边幅),并使用45 QAM的剩余数据流4。 这包括最新型的衰落信道,误码率计算,并
subimage
- Subimage.m is a MATLAB function that extracts a part of the image specified by its parameters. The image should be a binary image (e.g. not color image).Function elements: f-binary image m,n-dimension of extracted image rx,cy- starting point of
WimaxPhyLayerSimulationCode
- Simulation PHY layer of Wimax 802.16e, including Tx, Channel and Rx, baseband only.
2Tx-2Rx-Spatial-Multiplex
- 介绍了在MATAB中开发的MIMO通信系统的容量、误码率等问题。很适合初学MIMO的研究生或者科研人员-MATLAB simulation for MIMO capacity and BER
ofdm-Rx
- Matlab Code for OFDM Reciever
ofdm rx
- ofdm matlab code rx function of main program